1. Battery (wet,charged, plastic cased, 12 volt, 60 amp) - (1) - GBY5606

Not available mail order.

2. Tray (battery box liner) - (1) - RR1184

3. Battery Hold-Down Kit (standard bar with 8 1/8" 'J' bolts) - (1) - RB7165

4. Bar (battery hold down) - (1) - 157910

5. 'J' Bolt (battery hold-down, 8 1/8") - (2) - 610798

'J' Bolt (battery hold-down, 7") - (2) - 618434

Alternative.

'J' Bolt (battery hold-down, 5 3/4") - (2) - 613051

Alternative.

6. Nut (nyloc) - (2) - GHF221

7. Washer (plain, 1/4" x 9/16" OD) - (2) - WP127

8. Nut (wing) - (2) - 132068

Alternative to nyloc nut.

9. Washer (locking) - (2) - GHF331

Alternative to nyloc nut.

10. Rubber (battery shelf) - (1) - 613155

11. battery Cable Kit - (1) - RR1437

All CP/CF models.

Battery Cable Kit - (1) - RR1438

All CR/CF models.

12. Cable Assembly (battery, negative, to earth) - (1) - 516508

13. Screw (earth cable to bulkhead) - (1) - HU805

14. Washer (locking) - (1) - GHF332

15. Cable Assembly (battery, positive, to starter solenoid) - (1) - 517081

All CP/CC models.

16. Cable Assembly (battery, positive, to starter solenoid) - (1) - 159805

All CR/CF models.

17. Bolt (clamp terminal) - (2) - 518903

18. Nut (clamp terminal) - (2) - 518904

19. 'P' Clip (insulated, positive cable) - (1) - 508185

20. Screw (clip securing) - (1) - 506185

21. Cleat (fir tree) - (1) - 145890

22. Boot (rubber, solenoid end of cable) - (1) - 115706

23. Clamp Terminal Assembly (negative)* - (ar) - GHF2750

Clamp Terminal Assembly (positive)* - (ar) - GHF2755

24. Ring Terminal* - (ar) - LUCWB600

Battery Charger

29. Battery Charger (6 and 12 volt) - (1) - GAC7106

Vehicle Security

25. 'Dis-Car-Nect' Starter Immobiliser) - (ar) - RX1356

26. Replacement Screw Knob - (ar) - RX1356KNOB

27. Replacement Fuse - (ar) - RX1356FUSE

How Does 'Dis-Car-Nect' Work? When leaving your car, simply remove the knob to isolate the starter circuit. The 16amp by-pass fuse will maintain current to all other electrical circuits - stereo memories, alarm etc. Because the starter motor draws over 150amps, any attempt to connect (hot-wire) the starter motor will instantly cause the by-pass fuse to blow, this immobilises the car until the knob is replaced. If this should happen, simply replace the 16amp fuse at your convenience. As an added advantage, the 'Dis-Car-Nect' will also prevent battery drain if you intend to store your car, simply unscrew the knob and remove the fuse. For extra security you can unscrew and remove the immobiliser knob completely.

Battery Conditioner

The battery charger that turns on and off automatically. Suitable for all 12 volt batteries (from 5AH to 100AH), this superb product constantly revitalises the battery cells - helping to extend cell life, without the danger of overcharging. Supplied complete with all fittings and operating instructions, the benefits are :- · Designed to be left connected for long periods. · Use without disconnecting vehicle electrics. · L.E.D. battery condition display. · Thermal cut-out facility. · 12 month guarantee. Optional Connector Kit: This secure and safe connector kit gives you the choice of using a 'quick plug' facility rather than crocodile clips.

28. Battery conditioner kit - (1) - RX1410
Connector kit (optional) - (1) - RX1411



Return to TR6 Electrical Index      Return to TR6 Index Page

Home About Rimmer Bros. Prices General Info Delivery How to Order Your Order Form
News Restoration Projects Picture Library Triumph Links Free Catalogue Contact Us